Difference between revisions of "PLOrk speaker building notes"

From CSWiki
Jump to: navigation, search
Line 1: Line 1:
[[Current_to_do_list]] (A list of problems and stuff that needs fixing)
+
[[Current_to_do_list]] (A list of problems and stuff that needs fixing)
  
 
A place for useful notes on building the new silver hemispheres, sorted by step:
 
A place for useful notes on building the new silver hemispheres, sorted by step:

Revision as of 17:13, 13 April 2008

Current_to_do_list (A list of problems and stuff that needs fixing)

A place for useful notes on building the new silver hemispheres, sorted by step:

The Exoskeleton

  • Make sure feet are in the right place BEFORE drilling holes for the amps. :-(
  • Screw holes:
    • Amps: 5/32"
    • Power jack: 7/16"
    • Pot.: 3/8"
  • Don't break drill bits.

The Guts

  • Audio wires from the RCA sextet to the 6-channel pot need to be a little longer than we first thought: 14"-16" inches
  • The white wire with the blue stripe (attached to the amps) is junk - replace all of that
  • Striped wire = +12v
  • Scott's new color-coding for the RCA sextet: 1 = Blue, 2 = Blue/Black, 3 = Orange, 4 = Orange/Black, 5 = Green, 6 = Green/Black
  • Numbering for the RCA jacks on the bottom of the speaker:
    • W: 5 4 2
    • R: 6 3 1

Preparing the rings and drivers

  • The sticky stuff on the foam rings for the drivers isn't too good - a lot of them fell off over night. Maybe save this step until the drivers are ready to be screwed on to a hemi.

Installing The Drivers

  • Don't forget to put the ring over the wire before soldering the speaker to it. Forgetting to do this is lame. Current score: Dan: 5 or more, Jascha: 2, Cameron: 1. dan wins!!!
  • Trim the excess tape from the screw-holes with something before putting the screws in - not doing this can sometimes gum the screws up and make it annoying and needlessly difficult to get them in.